Tuckin’

Finally getting more progress done with the Kaiju Bike. After the stage 1 was complete we moved on to setting up the rear frame for an ATRtuck setup. The plan is to keep the bike clean and simple, so hopefully this will help that category.

Here is the ATR 11 Pole Wire Harness we got from SF.

Drilling the holes was the most time consuming part due to steps we needed to take. Making sure that we didn’t over do anything or go outside the boundary.

Preview of the ATRtuck

More Drilling!

After all the holes have been drilled out it was time to modify the bung fitting for the rear frame. (Showing sparks is a must have in all build post! haha.)

Time to start welding…. LoS out!

Tagged , , , , , ,

Leave a Reply

Your email address will not be published. Required fields are marked *